Laview camera default password

How do I reset my LaView password?

Special “Serial No.” will appear. showing on the screen and a secure code will be sent. and hit ok. The password should be reset back to 12345(some models will require a new password).

How do I reset my LaView camera?

Hold down the button, with the power still disconnected. While still holding the button down, plug power into the camera and continue to hold the button for 30 seconds. After 30 seconds from the power being plugged in, release the reset button and the camera should reboot and be set back to factory defaults.

What is the default password for Vivotek IP cameras?

Vivotek: root/ Ubiquiti: ubnt/ubnt. Uniview: admin/123456.

How do I setup my LaView camera?

Go to Main Menu>Camera>Camera. Tap the green “+” icon on an empty channel and enter in the IP address for your camera. In the password section, enter the “Verification Code” that is on the label of your camera. Tap “Ok” and give the LaView NVR 30 seconds to connect to your camera.

How can I break my DVR admin password?

To reset password of your CCTV DVR press and hold the ENTER button for 15 to 30 second until the DVR restart’s. After the restart you DVR default wizard will come up the same way like if you are setting up the DVR for the first time.

How do I reset my DVR to factory settings?

Factory Reset Instructions

  1. First, make sure that the unit is turned off.
  2. Then press and hold any button on the included infrared remote control.
  3. While holding the button on the remote, power on the unit.
  4. You should hear a single beep followed by a double beep. …
  5. Now that the DVR is booted, it will be set to the factory default settings.
You might be interested:  How to load a polaroid camera

How do I reset my Lorex dome camera?

To restore the camera to default settings:

Remove the dome camera cover. Press and hold the reset button below the camera module for at least 10 seconds. While still holding the reset button, disconnect and reconnect the Ethernet cable. Hold the button for 15 seconds before releasing.17 мая 2018 г.

What is foscam default password?

The default username to log into the camera is admin, the default password would be left blank, do not enter any characters into the password field. There are two different login buttons.

What is IP camera password?

By default, the IP Camera’s administrator password is admin. And you can change the password on User Management page. If you forget the password, the only way is to reset the IP Camera to factory default setting via hardware reset button.

What is IP camera activation password?

In earlier versions of the firmware (to version 5.3. 0) IP cameras HIKVISION supplied to IP address 192.0. 0.64 and the default password is 12345. Starting with version 5.3. … 0 and above before connecting to the network need to “activate” because they come from the factory without password (not active).

How do I connect my phone to LaView?

LaView Mobile P2P Set Up

  1. Click on the “+ Device” option.
  2. Go to DVR, Main Menu>Configuration>Network>P2P then scan QR code or manually enter Device ID and password.
  3. Press the “Save” button to be taken to the device list.
  4. Select Device and select cameras. Press “Play” for Android or “Live” for iPhone to start live view.
You might be interested:  How to transfer pictures from canon camera to computer

Leave a Reply

Your email address will not be published. Required fields are marked *