How to reset zmodo camera

How do I reset my Zmodo camera?

Please reset your device by pressing and holding the reset pin on the bottom of the Greet until the LED ring turns off. Wait for it to power back on, and retry the setup process once the LED ring is blinking green.

Where is the reset button on a Zmodo camera?

CM-I11123BK / CM-I12316GY – Reset to Defaults

For the CM-I11123BK, flip the camera upside down and locate the “RESET” button on the bottom of the base. Press and hold the button for 15 seconds.

How do I reset my Zmodo camera to a new WiFi?

To move your camera to a different Wi-Fi network:

Plug your camera into a power source in the new location, launch the MeShare app from your smartphone, and login with your existing username. Add the device again using the same setup process as before, but inputting the new network name and password.

Why wont my Zmodo connect?

If you have a Zmodo camera that won’t connect to Wi-Fi there’s a quick fix. Usually the issue with Internet connection is related to the frequency the camera is operating at. When your router works at 2.4Ghz and 5Ghz, the Zmodo camera can associate itself to the wrong SSID (wireless signal name).

How do I factory reset my Funlux camera?

To reset the camera, use a pin or a thin object to press and hold the reset pinhole on the back of the camera for 10 seconds. The LED Status Light will off and then start blinking green when the camera is ready to be set up again.

You might be interested:  How to white balance camera

What does red light mean on Zmodo camera?

A solid red light on a security camera means there is NOT a local internet or an internet connection.

How do I fix my Zmodo offline?

Disconnect the camera from the power, wait 5 seconds, and plug it back in. Do the same reboot with the NVR system. Not able to pull up camera on Internet Explorer: If you were not able to pull up your camera through its IP Address on Internet Explorer, you will want to reset the camera back to defaults.

How do I access my wireless router settings?

How to Gain Access to a Router

  1. Click the Windows logo located on the left side of the taskbar.
  2. Click the Settings icon.
  3. Choose Network & Internet.
  4. Click View your network properties.
  5. Scroll down and look for “Default gateway.”
  6. The number next to it is your router’s IP address.

Where is the reset button on Iegeek camera?

The reset button is on 1 of the 3 cables of the camera.

How do I reset my WIFI camera?

Factory reset your Insteon Wi-Fi Camera

  1. Connect your camera to your router using an ethernet cable.
  2. Ensure your camera is connected to power.
  3. Use a straightened paperclip to press and hold the recessed reset button for 10 seconds.

Leave a Reply

Your email address will not be published. Required fields are marked *